AWD 彈弓一問

有無人用京商出的AWD彈弓？
好唔好？

I have PN spring when I use it my car lost control when I turn.
My setup is as following:

- Benz CKL Vodafone
- AD PCB no fet
- AD Stock motor
- 19/29 A2/B2
- PN Motor heat sink
- Front 1 Degree Camber, Rear 2 Degree Camber
- Front & Rear Atmoic ball diff.

Can you share how you set up your front and rear using PN spring?

I use atomic 20 degree no pattern front
rear atomic 10 degree with pattern

I used double tape to stick my tyre.

What colour of PN springs shall be apply in front and rear?
White front and Green at rear?

For the shims, 0.4mm on top of the spring? 0.8mm on the bottom of kucnkle?

Thanks ganboy.

Finally I get the setting done and now is ok... even though not perfect...

I think I will go for SAS on my next stage.

For the shims, if I remove some from the bottom or below spring how will it affect the turning?