標題: 電單車 Problem during assembly [打印本頁] 作者: jas 時間: 2006-11-5 18:10 標題: 電單車 Problem during assembly I cannot fit the long shaft (13) into (14). Shaft too thick or hole on (14) too small.
Anyone else got the same problem? What can I do?
Thx!
[ 本帖最後由 Ken 於 2006-11-5 19:19 編輯 ]作者: beebee 時間: 2006-11-5 19:06
用"沙紙"磨吓條中軸尾部就得啦~~作者: pat1111 時間: 2006-11-5 21:37
我就開大少少14個 hole 呀作者: jas 時間: 2006-11-5 21:59
Thanks for the replies.
I did some measurements with the digital caliper. The hole is less than 2.95mm, and the shaft is 3.05. That means there is 0.1mm difference in diameter. I can't believe Kyosho allows this kind of tolerance.
Anyway, I will try sanding down the shaft, since I don't have a drill.